In any of your searches for exhaust have any of you found exhaust tips like the concept? I like thoes alot better then the one on the cars now.

 

The ones on the concept were one-of-a-kind custom made. I don't think that you will find anything to match them.

 

oh really
http://cgi.ebay.com/ebaymotors/1970-...mZ120260113022

 

Those are made for the 70's Challenger. Could you make them work on the new one? Probably. But you might have to do some cutting/welding, and they may not fit right in the rear bumper properly.

 

I was planning to add the "correct Quad tips" to my new Challenger. Does anyone have the measurements of the new Challenger tips?

 

I realize they are for the 70-74 challenger, I just hadn't seen anything like this available before (must not have looked hard enough). I will probably remove the entire exhaust system and put on headers and stainless all the way back no mufflers and use tips similar to the ones above. The only question is weather if will fit right in the bumber.

 

I'm sure the aftermarket will take care of this.

 

2 1/2 inches is too small for the 6.1L engine. It takes 2 3/4 inches. The 6.4L, if it ever is built, will take even bigger. I would check with a muffler shop.

Dave

 

they have them all the way up to 3 inch, so im not worried about getting them to fit.
And thats what i was asking is if anyone has seen an after market set up similar to the concept ones.