The parts arrived from MOPAR and it took me less than 5 minutes to install the hood struts.

On the R/T and S/E models............The stud on the hood itself is already there from the factory.

You then have to install the new studs on the body, the hole is already there. (A 1/2 inch socket works great.)

You then need to use a small flat screwdriver to slide away the retaining clips on the ends of the strut.

Then place the strut ends on to the studs and then push the retaining clip back down - then it will grab the stud.

Make sure that you keep the prop rod in place through out this installation so that the hood doesn't fall.

Another tip: You'll need to raise the hood higher than the prop rod position by placing a rag on the end of the prop rod.

In the end, the hood opens and closes with ease. I decided to leave the prop rod in place - just in case of a failure of the struts.