Notices
Dodge Challenger SE Threads specific to the Dodge Challenger SE should be placed here.

Well I don't drive a General Lee

Thread Tools
 
Old 02-02-2010 | 10:21 PM
  #41  
canadiancanuck's Avatar
Thread Starter
Senior Member
 
Joined: Nov 2008
Posts: 506
Likes: 0
From: Calgary, Alberta Canada
Default

the new car has been good, the problem I had with the old car was I was highway speed when the engine cut out, so braking was a bit tough at 70kms and fastly approaching the rear of a tractor trailer, and very little time to really steer to react, so I did what I could and veered to eth left but it was tough to fight it back to the right but I caught some of the side road and down the ditch I went. So it's not like I had 0 control I was probably at 20-25% controlabilty.

oh well, just installed my JBA headers tonight, 4hrs and on my own, it was a duanting task however I got it done, and my sequential tail lights showed up tonight so those are tomorrow.
Old 02-03-2010 | 05:11 AM
  #42  
wp23n's Avatar
Senior Member
 
Joined: Apr 2009
Posts: 341
Likes: 0
From: northeast
Default

Originally Posted by canadiancanuck
oh well, just installed my JBA headers tonight, 4hrs and on my own, it was a duanting task however I got it done, and my sequential tail lights showed up tonight so those are tomorrow.
any issues with the install or straight up.
Old 02-03-2010 | 08:07 AM
  #43  
canadiancanuck's Avatar
Thread Starter
Senior Member
 
Joined: Nov 2008
Posts: 506
Likes: 0
From: Calgary, Alberta Canada
Default

I'm not going to lie to you, the Pain in the ass factor is high, but all in all if you pay attention, and don't get worked up , this should be a fairly straight foward install.

sequential lights go in tonight.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BLK 6050
General Dodge Challenger Discussions
22
11-15-2008 05:15 AM
Cuda340
Challenger News
4
08-15-2008 05:31 PM
Cuda340
General Dodge Challenger Discussions
1
08-15-2008 10:36 AM
108Challenger
New Member Area
33
05-30-2008 10:39 AM
GENX_HEMI9
Audio/Video Electronics
6
07-20-2006 05:35 PM




All times are GMT -8. The time now is 10:40 PM.